- Emergency lighting kit for ﬂuorescent lamps from 6 to 80 Watts
- Approx. 20% emergenty lighting for one or three hours
- Maintained or non-maintained operation
- Slim version for narrow light ﬁttings
- Potted version for explosion proof ﬁttings
The TLX range of emergency control units cover all axial ﬂuorescent lamps as well as four pin compact types from 6 to 80 Watts. The following versions provide an emergency lighting duration of either one or three hours:
|VERSION||BALLAST TYPES||DURATION||BATTERY PACK (ni-cad)||FLOURESCENT LAMPS|
|TLX5/1hr||Switch Start||one hour||5 x 2 Ahr cells||up to 65 Watts|
|TLX5/3hr||Switch Start||three hour||5 x 2 Ahr cells||up to 65 Watts|
|TLX5/1hr/E||All||one hour||5 x 2 Ahr cells||up to 80 Watts|
|TLX5/3hr/E||All||three hour||5 x 2 Ahr cells||up to 80 Watts|
The units comply with BS EN 60598-2-22, BS EN 60924 and SABS 1464: Part 22. A safety start circuit is provided that prevents emergency operation until rnains is connected. This enables installation without disconnecting or depleting the batteries. A red light indicates that the batteries are being charged. The unit is housed in a high quality glass sphere reinforced polyamide polymer. This material has excellent high heat resistance and impact strength properties. The emergency light output is sufﬁcient to satisfy most escape route and anti-panic area lighting requirements. The unit can be used with conventional switch start, electronic or dimming ballasts.
Note 1: The emergency lighting duration and light output may vary due to ambient temperature, cell type and lamp manufacturer.
Note 2: Any unit may be ordered in an explosion proof, potted housing (Zone 1 / 2 ﬁtting).
Also available in Li-ion version.
SPECIFICATIONS: (parenthesis = 3 hour versions)
|Mains voltage tolerance||(110Vac) 230Vac ±10% 50Hz|
|Lamp types||6 to 80 Watt flourescent lamps|
|Emergency lighting duration||(3 hours) 1 hour|
|Mains power consumption||2Va|
|Battery discharge current||1A|
|Deep discharge current||>0.8V/cell|
|Charging current||(200mA) 100mA|
|Quiescent current||< 1uA|
|Battery short circuit tolerance||indefinite|
|Maximum operating temperature||+70°C|
DIMENSIONS (L x W x H mm)
|Standard:||170 x 45 x 35 mm|
|Slimline:||251 x 30 x 30 mm|
|Explosion Proof:||175 x 40 x 40 mm|